How to keep you SUSPENDED plus pattern for CDS

Here is a fun lesson on suspending in the card
LETS BEGIN
(I use up all the heavy plastic covering
that the cartridges come in when you by them)
Cut a 2 inch square from heavy plastic waste

Cut out the card using the
cricut pattern FROM HERE
or the Sure cuts a lot pattern FROM HERE
You will also need
hole punch, white paint pen, four beads, thin ribbon,
tape and image
(in this case i used a fabric sticker LESSON HERE )

Start by using the white paint pen
and drawing around the edge of
the 2" square
(decorate in side this square is you want too, i did )
Put aside to completely dry

Punch 4 small hole one in each corner

Take the ribbon and thread it from the back of the
square to the front

and tie a knot or two so as it will not pull out

Doing this to all holes and cutting of enough ribbon
(in this case I cut mine about 4 " as to make sure
i had enough to hold)

Thread the beads onto each ribbon (don't tie it yet)

With your top card put tape all way round

take the tape of two of the sides and
position the the square in the center
making sure your ribbons are laying flat on
the tape

Now place another piece of tape
over the ribbons

Move the beads to touch the frame and tie not above
them to hold them in place

Trim of excess ribbon

Mount it on your base card

Add your sticker

Now complete

HERE is another cards using
this idea

Spring